LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Vibe GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 1.8L (LV6)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different variant/trim than selected.
  1. Use new engine oil in order to coat the new guide tube seal.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the new guide tube seal (1) to the guide tube. Secure the guide tube to the cylinder block using one bolt (3).

    Tighten 

    Tighten the bolt to 14 N.m (10 lb ft).

  3. Install the oil level indicator to the guide tube.
    Fig 1: Installing Oil Level Indicator & Tube
    G01547019Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals