Removal & Installation (Driver-side)

Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 3 under DISABLING & ACTIVATING AIR BAG SYSTEM.
Remove bolts retaining driver-side air bag module to steering wheel. Remove Connector Position Assurance (CPA) clip from driver-side air bag module connector. See Fig 1. Disconnect air bag module connector. Remove driver-side air bag module.
To install, reverse removal procedure. Tighten driver-side air bag module bolts to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ZONE 3 under DISABLING & ACTIVATING AIR BAG SYSTEM.>>

Fig 1: Identifying Driver-side Air Bag Module

Courtesy of GENERAL MOTORS CORP.