LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Vibe Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Automatic Transmission - Mu4) >> Automatic Transmission Oil Cooler >> Vehicle Speed Sensor (VSS) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative (-) battery cable.
  2. Disconnect the vehicle speed sensor (VSS) electrical connector.
  3. Remove the 1 retaining bolt (1) and the VSS (2) from the transaxle.
  4. Inspect the VSS O-ring for cuts or damage. Replace as necessary.
    Fig 1: Removing 1 Retaining Bolt And VSS From Transaxle
    G03415461Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals