LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Vibe Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Automatic Transmission - Mu4) >> Automatic Transmission Oil Cooler >> Vehicle Speed Sensor (VSS) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Apply J 36850  to the VSS O-ring.
  2. Install the Vehicle Speed Sensor (VSS) into the transaxle case. Secure the VSS (2) with the retaining bolt (1).

    Tighten 

    Tighten the VSS speed sensor (VSS) bolt to 6 N.m (53 lb in).

  3. Connect the VSS electrical connector.
  4. Connect the negative (-) battery cable.
    Fig 1: Installing Vehicle Speed Sensor (VSS) Into Transaxle Case
    G03415462Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals