LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Vibe Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Automatic Transmission - Mu4) >> Automatic Transmission Oil Cooler >> Automatic Transmission Mount Replacement Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the 3 left transaxle bracket and bolts.

    Tighten 

    Tighten the transaxle bracket bolts to 80 N.m (59 lb ft).

  2. Install the left transaxle mount and the 4 bolts.

    Tighten 

    Tighten the left transaxle mount bolts to 52 N.m (38 lb ft).

  3. Install the transaxle mount through bolt.

    Tighten 

    Tighten the transaxle mount through bolt to 80 N.m (59 lb ft).

  4. Remove the engine support fixture.
  5. Install the air cleaner box.
  6. Install the 3 air cleaner box bolts.
  7. Install the air filter.
  8. Install the air cleaner hose and cap assembly.
  9. Install the IAT sensor.
  10. Connect the IAT connector.
  11. Install the battery tray and battery. Refer to BATTERY REPLACEMENT in Engine Electrical
  12. Install the hold down bracket.
  13. Install the hold down bracket bolt and nut.

    Tighten 

    Tighten the hold down bracket bolt and nut to 12 N.m (106 lb in).

  14. Install the positive and negative battery cables.
scientia non olet · About LEMON Manuals