LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Vibe Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Automatic Transmission - Mu4) >> Automatic Transmission Oil Cooler >> Automatic Transmission Mount Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the engine support fixture to support the engine.
  2. Remove the rear mount through bolt.
    Fig 1: Removing Rear Mount Through Bolt
    G03415481Courtesy of GENERAL MOTORS CORP.
  3. Raise and suitably support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  4. Remove the 3 nuts and 1 bolt securing the rear mount to the transmission support.
  5. Lower the vehicle.
  6. Remove the rear transaxle mount from the vehicle.
    Fig 2: Removing 3 Nuts And 1 Bolt Securing Rear Mount To Transmission Support
    G03415482Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals