LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Vibe Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission Removal & Installation - (Fwd)) >> Removal & Installation >> Transaxle Mount (Rear) >> Installation

Transaxle Mount (Rear): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the rear transaxle mount into the rear transaxle mounting bracket.
  2. Secure the rear transaxle mount with the through bolt. DO NOT fully tighten the through bolt.
  3. Raise and suitably support the vehicle.
  4. Install the 3 nuts and one bolt to secure the rear transaxle mount to the transmission support. See Figure . Tighten the nuts and bolt to specification. See TORQUE SPECIFICATIONS  .
  5. Lower the vehicle.
  6. Tighten the through bolt. See Figure . Tighten the through bolt to specification. See TORQUE SPECIFICATIONS  .
  7. Remove the engine support fixture from the engine.
scientia non olet · About LEMON Manuals