LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Vibe Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission Removal & Installation - (Fwd)) >> Removal & Installation >> Transaxle Mount (Front) >> Installation

Transaxle Mount (Front): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the front transaxle bracket and bolts. Tighten the transaxle bracket bolts to specification. See TORQUE SPECIFICATIONS  .
  2. Install the insulator to the mount bracket.
  3. Install the front transaxle mount through bolt. See Figure . Tighten the transaxle mount through bolt to specification. See TORQUE SPECIFICATIONS  .
  4. Install the 2 bolts to the front transaxle mount. Tighten the front transaxle mount bolts to specification. See TORQUE SPECIFICATIONS  .
  5. Install the left hand splash shield.
  6. Install the right hand splash shield.
  7. Lower the vehicle.
  8. Remove the engine support fixture.
scientia non olet · About LEMON Manuals