LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Vibe Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 147 (Engine Control System (Introduction) -- 1.8L (LNK)) >> Repair Instructions >> Secondary Air Injection (AIR) Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Solenoid Valve, Vacuum Hoses And Fastener
    GM1313453Courtesy of GENERAL MOTORS CORP.
  1. Install the AIR solenoid valve (2) to the intake manifold with the one fastener (1).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the AIR solenoid valve fastener (1).

    Tighten:  Tighten the fastener to 8.8 N.m (77 lb in).

  3. Connect the vacuum hoses (3) to the secondary AIR solenoid valve (2).
  4. Connect the electrical connector to the AIR solenoid valve.
scientia non olet · About LEMON Manuals