Installation Procedure
- Install the accessory power receptacle, if removed. Refer to ACCESSORY POWER RECEPTACLE REPLACEMENT
in Wiring Systems.
- Install the cigar lighter assembly, if removed. Refer to CIGAR LIGHTER REPLACEMENT
.
- Connect the following components:
- The 2 cigar lighter electrical connectors
- The accessory power receptacle electrical connectors
- Install the front floor console trim plate (2) to the front floor console assembly. Ensure that the retaining clips are fully engaged.
- Install the center screw (1).
- Install the center A/C control knob (3).
- Install the manual transmission shift knob, if equipped.
Courtesy of GENERAL MOTORS CORP.