Removal Procedure

Important:  The ignition switch must be in the OFF position when removing the instrument cluster assembly.

1. Remove the IP cluster trim plate. Refer to TRIM PANEL REPLACEMENT - INSTRUMENT PANEL (I/P) CLUSTER  .
2. Remove the screw (1) which secures the instrument cluster assembly (2).
3. Disengage the 2 lower clips (3).
4. Disconnect the electrical connector from the cluster assembly (2).
5. Remove the cluster assembly (2) from the instrument panel assembly.
   Fig 1: Removing Cluster Assembly From Instrument Panel Assembly

   Courtesy of GENERAL MOTORS CORP.