LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2003 >> Aztek FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim >> Repair Instructions >> Molding Replacement - Rear Wheel Opening >> Removal Procedure

Removal Procedure

  1. Remove the screws from the rear wheel opening molding.
  2. Pull the upper edge of the rear wheel opening molding out, to release the retainers.
  3. A thin, plastic flat-bladed tool may be used between the molding and the body to help release the wheel opening molding retainers.
  4. Remove the rear wheel opening molding from the vehicle.
    Fig 1: Removing Rear Wheel Opening Molding
    G01515610Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals