LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2002 >> Aztek FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Disabling & Activating Air Bag System >> Disabling System

Disabling System

WARNING: Accidental air bag deployment is possible. Personal injury may result. Read and follow service precautions. See AIR BAG SAFETY PRECAUTIONS .
NOTE: When SIR fuse is removed from junction block and ignition is on, AIR BAG warning light will be on. This does not indicate a system malfunction.
  1. Turn steering wheel to place vehicle wheels in straight-ahead position. Turn ignition off and remove key.
  2. Remove center console accessory wiring junction block cover. Remove SIR fuse from junction block. Remove driver-side insulator panel. See Fig 1. Remove Connector Position Assurance (CPA) clip and disconnect driver-side air bag module Yellow 2-pin connector, located at base of steering column.
  3. Remove passenger-side CPA and disconnect passenger-side air bag module Yellow 2-pin connector, located below glove box. See Fig 2. Remove CPA clip from driver side impact air bag module connector, located under driver-side front seat. See Fig 3. Disconnect driver side impact air bag module connector.
  4. Remove CPA clip from passenger side impact air bag module connector, located under passenger-side front seat. Disconnect passenger side impact air bag module connector.
Fig 1: Locating Driver-side Air Bag Module Yellow 2-pin Connector
G99C23798Courtesy of GENERAL MOTORS CORP.
Fig 2: Locating Passenger-side Air Bag Module Yellow 2-pin Connector
G99D23799Courtesy of GENERAL MOTORS CORP.
Fig 3: Locating Side Impact Air Bag Module Yellow 2-pin Connector (Driver-side Shown; Passenger-side Is Similar)
G99B23797Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals