LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2002 >> Aztek FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Disabling & Activating Air Bag System >> Activating System

Activating System

  1. Ensure ignition is off and key is removed. Connect passenger side impact air bag module 2-pin connector, located under passenger-side front seat. See Figure. Install Connector Position Assurance (CPA) clip.
  2. Connect passenger-side air bag module connector, located under glove box. See Figure. Install CPA clip. Connect driver side impact air bag module connector, located under driver-side front seat. Install CPA clip.
  3. Connect driver-side air bag module connector, located near base of steering column. See Figure. Install CPA clip. Install driver-side insulator panel. Install SIR fuse in junction block. Install center console accessory wiring junction block cover. Check system for proper operation. See SYSTEM OPERATION CHECK .
scientia non olet · About LEMON Manuals