Installation Procedure

Install the energy absorber to the rear fascia.
Install the rear parking assist object sensor to the rear bumper fascia. Refer to REAR PARKING ASSIST .
Partially install the rear bumper fascia.
Connect the rear parking assist electrical connector.

Fig 1: Disconnecting Rear Parking Assist Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Position the rear bumper fascia to the vehicle.
Engage the ball stud on each side of the rear bumper fascia.

Fig 2: Engaging Rear Bumper Fascia Ball Stud
Courtesy of GENERAL MOTORS CORP.
Starting at the center hole, install the push-in retainers to the lower rear bumper fascia.
Install the push-in retainers to the rear bumper fascia upper tabs.

Fig 3: Installing Push-In Retainers To Lower Rear Bumper Fascia And Upper Tabs
Courtesy of GENERAL MOTORS CORP.
Install the screws to the rear bumper fascia at the inboard side of the rear quarter panel.
Close the endgate.

Fig 4: Installing Rear Bumper Fascia At Rear Quarter Panel Inboard Side Screws
Courtesy of GENERAL MOTORS CORP.