LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Master Cylinder >> Installation

Master Cylinder: Installation

  1. Install the master cylinder reservoir. See MASTER CYLINDER RESERVOIR .
  2. Bench bleed the master cylinder prior to installation. See MASTER CYLINDER BENCH BLEEDING  under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.
  3. Install the master cylinder. See MASTER CYLINDER RESERVOIR .
  4. Install the master cylinder mounting nuts. Tighten the master cylinder mounting nuts to specification. See TORQUE SPECIFICATIONS .
  5. Connect the fluid level sensor electrical connector.
  6. Connect the brake pipes to the master cylinder. Tighten the master cylinder tube nuts to specification. See TORQUE SPECIFICATIONS .
  7. Fill the master cylinder reservoir with brake fluid. See MASTER CYLINDER RESERVOIR  under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.
  8. Bleed the brake system. See HYDRAULIC BRAKE SYSTEM BLEEDING  under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.
Fig 1: Removing & Installing Master Cylinder From Power Brake Booster
G00076414Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals