LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2002 >> Aztek AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Brake Pedal Assembly >> Removal

Brake Pedal Assembly: Removal

  1. Disable the SIR system. See appropriate AIRBAG article in RESTRAINTS.
  2. Remove the left side insulator panel.
  3. Remove the booster push rod from the brake pedal.
  4. Disconnect the electrical connectors from the cruise control release if equipped and stoplight switch.
  5. Remove the knee bolster.
  6. Remove the brake booster mounting nuts.
  7. Remove the brake pedal bracket mounting nuts. See Fig 1.
  8. Remove the upper mounting nuts from the brake pedal brace.
  9. Remove the brake pedal with the bracket.
  10. Remove the brake pedal brace from the bracket.
  11. Remove the cruise control release switch, if equipped, and the stoplight switch from the brake pedal with the bracket.
Fig 1: Exploded View Of Brake Pedal and Mounting Hardware
G00076413Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals