Wiper Motor Cover Replacement

REMOVAL PROCEDURE




1. Remove the wiper system drive module. Refer to Wiper Motor Module Replacement.
2. Remove the wiper motor cover screws.
3. Remove the wiper motor cover from the wiper motor.

INSTALLATION PROCEDURE




1. Position the wiper motor cover to the wiper motor.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the wiper motor cover screws.

Tighten
Tighten the screws to 3 N.m (27 lb in).

3. Install the wiper system drive module. Refer to Wiper Motor Module Replacement.