LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek V6-3.4L VIN E >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Service and Repair >> Overhaul >> Repair Instructions >> 94. Case Cover Bearing Assemble

94. Case Cover Bearing Assemble

Case Cover Bearing Assemble

^ Tools Required
- J 8092 Driver Handle
- J 41991 Bearing Remover/Installer Driveshaft Bearing Remover/Installer





1. Assemble J 8092 and J 41991 Bearing Remover/Installer for bearing installation.
2. Place the case cover (400) on a clean, flat surface with the case mating surface up.

Important: When installing the new bearing the part number should be visible (facing upward).

3. Using the assembled tool, press the drive shaft bearing (431) into the case cover (400).
scientia non olet · About LEMON Manuals