126. Output Shaft Assemble

Output Shaft Assemble





1. Inspect the output shaft (510) for:
^ Damaged bushing journals
^ Stripped splines
^ Snap ring groove damage





2. Affix the outboard drive shaft retaining ring (509) and the inboard drive shaft retaining ring (509) onto the output shaft (510).





3. Rotate the transmission so that the oil pan flange faces downward.

Notice: Do not push to hard during installation of the output shaft (510), or damage to the bushings or bearings may occur.

4. Carefully install the output shaft (510) into the transmission. Extend the shaft through the differential side gear.