102. Vehicle Speed Sensor (VSS) Assemble (FWD Only)

Vehicle Speed Sensor (VSS) Assemble (FWD Only)

Important: Handle the vehicle speed sensor assembly carefully.





1. Inspect the vehicle speed sensor assembly (10) and the vehicle speed sensor O-ring seal (11) for the following conditions:
^ Damaged connector
^ Cracked housing
^ Signs of rotor damage
^ Cuts or nicks on the O-ring seal
2. Install a new O-ring seal (11) on the vehicle speed sensor assembly (10).





3. Install the vehicle speed sensor assembly (10) into the case extension.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the vehicle speed sensor bolt (9).
^ Tighten the bolt to 12 Nm (106 inch lbs.).