Forward Servo Replacement (M76)

Forward Servo Replacement (M76)

Removal Procedure





1. Remove the Transaxle assembly.
2. Remove the transfer case.
3. Remove the forward band servo cover bolts.
4. Remove the forward servo cover.
5. Remove the forward servo cover O-ring.
6. Remove the servo piston assembly.
7. Remove the servo spring.
9. Using the J 6125-B with the J 6125-1B and the J 23129 remove the wheel drive shaft oil seal (1) from the transmission.

Installation Procedure





1. Use a light wipe of transaxle fluid to lubricate the seal lip.
2. Install the J 37292-B into the new seal (409).
3. Using the J 34115 install a new seal (409).

Important: Carefully guide the axle shaft past the lip seal. Do NOT allow the shaft splines to contact any portion of the seal lip surface or damage to the seal will occur.

4. Install the wheel drive shaft to the transaxle.
5. Remove the J 37292-B.
6. Install the left lower ball joint to the lower control arm.
7. Install the left tie rod end to the left steering knuckle.
8. Install the left stabilizer shaft bracket to the left lower control arm.
9. Install the left engine splash shield.
10. Install the left front tire and wheel assembly.
11. Lower the vehicle.
12. Refill the automatic transmission with automatic transmission fluid.
13. Inspect for automatic transmission fluid leaks.