Front

Removal Procedure





1. Raise and support the vehicle.
2. Remove the stabilizer shaft link bolt and nut.
3. Use a pry bar in order remove the stabilizer shaft link insulators and the spacer.

Installation Procedure





1. Use a pry bar in order install the stabilizer shaft link insulators and the spacer.
2. Install the stabilizer shaft link and insulators.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the stabilizer shaft link bolt and nut.
^ Tighten the stabilizer shaft link nut to 23 Nm (17 ft. lbs.).
4. Lower the vehicle.