(Rear Bushing - All Wheel Drive)

Removal Procedure





1. Raise and support the vehicle.
2. Remove the wheel and tire assemblies.
3. Remove the coil spring (2).





4. Remove the lower control arm to crossmember mounting bolts (1, 5).
5. Measure and record the installation depth of the bushing in the control arm.
6. Make a mark on the control arm in line with the flat edge of the bushing flange in order to identify the rotational orientation of the bushing in the control arm.
7. Use a press in order to remove the bushing.

Installation Procedure





1. Make a mark on the bushing at the same installation depth and orientation as the old bushing.
2. Use a press in order to install the bushing to the control arm.
3. Install the lower control arm and mounting bolts (1, 5).





4. Install the coil spring (2).
5. Install the wheel and tire assemblies.
6. Inspect the rear camber and toe angles and adjust as necessary.
7. Lower the vehicle.