Power Steering Pump Replacement

Removal Procedure





1. Remove the wiring harness from the wiring harness retainer located on the power steering pump reservoir.
2. Remove the accessory drive belt from the power steering pump pulley.
3. Remove the power steering pressure hose from the power steering pump.





4. Remove the power steering return hose from the power steering pump.





5. Remove the power steering pump mounting bolts from the power steering pump.
6. Remove the power steering pump from the vehicle.
7. Remove the power steering pump pulley from the pump.
8. Remove the power steering pump reservoir from the power steering pump.

Installation Procedure





1. Install the power steering pump reservoir to the power steering pump.
2. Install the power steering pump pulley to the power steering pump.
3. Position the power steering pump to the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the power steering pump mounting bolts.

Tighten
Tighten the power steering pump mounting bolts to 34 Nm (25 lb ft).





5. Install the wiring harness to the wiring harness retainer located on the power steering pump reservoir.
6. Install the power steering return hose to the power steering pump.





7. Install the power steering pressure hose to the power steering pump.
8. Install the accessory drive belt.
9. Flush the power steering system.
10. Bleed the power steering system.
11. Inspect the system for leaks.