Rear

REMOVAL PROCEDURE




1. Open the seat belt guide loop cover.
2. Remove the bolt from seat belt guide loop.




3. Remove the seat belt guide loop from the pillar.




4. Remove the bolt from the rear seat belt lower anchor.




5. Remove the rear seat belt lower anchor.




6. Remove the rear quarter lower trim panel.
7. Remove the bolt from the rear seat belt retractor.




8. Remove the rear seat belt retractor from the rear quarter inner panel.
9. Remove the rear seat belt retractor assembly from the vehicle.

INSTALLATION PROCEDURE




1. Install the rear seat belt retractor to the rear quarter inner panel.

NOTE: Refer to Fastener Notice in Service Precautions.




2. Install the bolt to the rear seat belt retractor.

Tighten
Tighten the rear seat belt retractor bolt to 42 N.m (31 lb ft).




3. Install the rear quarter lower trim panel.
4. Place the rear seat belt lower anchor to the lower rear quarter lower trim panel.




5. Install the bolt to the rear seat belt lower anchor.

Tighten
Tighten the rear seat belt lower anchor bolt to 42 N.m (31 lb ft).




6. Place the seat belt guide loop to the pillar.




7. Install the bolt to seat belt guide loop.

Tighten
Tighten the rear seat belt guide loop bolt to 42 N.m (31 lb ft).

8. Close the seat belt guide loop cover.