Rear (Split Bench)

REMOVAL PROCEDURE




1. Remove the right and/or left rear split bench seat from the vehicle.
2. Place the rear bench seat with the bottom of the rear bench seat in the upward position.
3. Remove the rear bench seat trim to access the right and/or left rear seat belt buckle anchor.
4. Remove the bolt from the right and/or left rear bench seat belt buckle anchor.




5. Remove the rear seat belt buckle from the right and/or left rear seat belt anchor pulling the seat belt buckle through the slot in the rear seat cushion.

INSTALLATION PROCEDURE




1. Install the rear seat belt buckle to the right and/or left rear seat belt anchor pulling the seat belt buckle through the slot in the rear seat cushion.

NOTE: Refer to Fastener Notice in Service Precautions.




2. Install the bolt to the right and/or left rear bench seat belt buckle anchor.

Tighten
Tighten the right and/or left rear seat belt buckle anchor bolt to 42 N.m (31 lb ft).

3. Install the rear bench seat trim.
4. Install the right and/or left rear split bench seat to the vehicle.