Secondary Air Injection (AIR) Pump Inlet Hose/Duct Replacement

REMOVAL PROCEDURE




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the fasteners from the front portion of the left front wheel well and/or splash shield.
3. Reposition the splash shield to gain access to the inlet hose.
4. Remove the inlet hose from pump.
5. Transfer the inlet filter.

INSTALLATION PROCEDURE




1. Install the inlet hose to pump.
2. Raise the wheel well and/or splash shield into position.
3. Install the wheel well and/or splash shield fasteners.
4. Lower the vehicle.