Head Up Display Module Replacement

REMOVAL PROCEDURE




1. Remove the IP upper trim pad.
2. Disconnect the electrical connectors.
3. Remove the bolts that secure the heads up display module to the IP.
4. Remove the heads up display module.

INSTALLATION PROCEDURE




1. Install the heads up display module.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the bolts that secure the heads up display module to the IP.

Tighten
Tighten the bolts to 2 N.m (18 lb in).

3. Connect the electrical connectors.
4. Install the IP upper trim pad.