Instrument Panel (IP) - Accessory Trim Plate Replacement

Instrument Panel Accessory Trim Plate Replacement

Removal Procedure

1. Position the floor shifter in the Drive position.
2. Remove the front floor console. Refer to Front Floor Console Trim Plate Replacement (Front Floor Console Trim Plate Replacement).
3. Remove 2 screws from the lower trim plate.




4. Remove the instrument panel (I/P) accessory trim plate by releasing the retainers.

Installation Procedure




1. Align the retainers on the I/P accessory trim plate to the slots in the I/P.
2. Install the retainers into the slots until the retainers are fully seated.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the 2 screws to the lower trim plate.

Tighten the screws to 2 Nm (18 lb in).

4. Install the front floor console. Refer to Front Floor Console Trim Plate Replacement (Front Floor Console Trim Plate Replacement).