IP Air Outlet Ducts Replacement

REMOVAL PROCEDURE




1. Remove the IP. Refer to Trim Pad Replacement - IP Upper in Instrument Panel, Gages and Console.
2. Lift up on the retaining tab and rotate the air distribution extension duct.




3. Remove the air distribution extension duct from the cross vehicle beam.

INSTALLATION PROCEDURE




1. Align the tabs Of the air distribution extension duct with the slots in the cross vehicle beam.




2. Rotate the distribution extension duct to secure the retaining tab to the cross vehicle beam.
3. Install the IP, Refer to Trim Pad Replacement - IP Upper in Instrument Panel, Gages and Console.