Master Cylinder Reservoir Replacement

Master Cylinder Reservoir Replacement

Removal Procedure

1. Remove the master cylinder.

Notice: Do not overtighten vise, or damage to the master cylinder will result.

2. Clamp the flange on the master cylinder body in a vise. Do not clamp the master cylinder body.





3. Drive out the spring pins. Use a suitable punch. Do not damage the reservoir or the cylinder body when pushing out the pins.





4. Remove the reservoir body (3) by pulling the body straight up and away from the cylinder body.
5. Remove the O-rings (4) from the grooves in the reservoir.
6. Inspect the reservoir for cracks or deformation. Replace the reservoir if necessary.
7. Clean the reservoir. Use clean denatured alcohol.
8. Dry the reservoir. Use non-lubricated compressed air.

Installation Procedure

1. Lubricate the new O-rings and the reservoir-to-housing fittings. Use clean brake fluid.





2. Insert the O-rings (4) into the grooves in the reservoir. Ensure that the O-rings are properly seated.
3. Install the reservoir (3) to the master cylinder body. Use your hand in order to push the reservoir straight down into the body.





4. Install the spring pins in order to retain the reservoir. Do not damage the reservoir or the cylinder body.
5. Install the master cylinder.