Weatherstrip Replacement - Rear Door Window

REMOVAL PROCEDURE




1. Place the rear window in the full down position.
2. Remove the trim panel.
3. Remove the water deflector.
4. Remove the outer belt sealing strip.
5. Remove the screw from the rear window channel.
6. Remove the channel from the rear door.

INSTALLATION PROCEDURE




1. Position the channel to the rear door starting in the corner.
Work outward in both directions.
2. Firmly seat the channel to the rear door.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the screw to the rear window channel.

Tighten
Tighten the screw to 10 N.m (89 lb in).

4. Inspect the rear door window for proper operation.
5. Install the outer belt sealing strip.
6. Install the water deflector.
7. Install the trim panel.