Rear Door Window Belt Outer Sealing Strip Replacement

Rear Side Door Window Outer Sealing Strip Replacement

Removal Procedure




1. Position the rear window all the way down.
2. Remove the outer belt sealing strip screw.
3. Pull the outer belt sealing strip from the rear door pinchweld flange.

Installation Procedure




1. Position the outer belt sealing strip to the rear door pinchweld flange.
2. Install the sealing strip to the pinchweld flange, pressing into place until full seated.

Notice: Refer to Fastener Notice .

3. Install the outer belt sealing strip screw.

Tighten the screw to 2 Nm (18 lb in).