Rear 50-50 Split Seat Replacement

Rear 50-50 Split Seat Replacement

Removal Procedure

1. Place the seat back fully forward.




2. Pull the release strap on the back side of the seat adjuster or pull the release handle on the side of the rear seat in order to release the adjuster from the floor.
3. Lift the rear of the rear seat fully upwards and forward.
4. Lift the rear seat from the anchor plate.
5. Remove the rear sear from the vehicle.

Installation Procedure

1. Place the rear seat to the anchor plates.




2. Install the front seat adjuster latches into the anchor plate.
Ensure that the latch is hooked on both pins.
3. Tilt the rear seat assembly down and latch the seat adjuster into the floor.
4. Install the rear seat to its original position.