Seat Cushion Inner Trim Panel Replacement (Rear Bucket)

Seat Cushion Inner Trim Panel Replacement (Rear Bucket)

Removal Procedure

1. Remove the rear bucket seat from the vehicle. Refer to Rear Bucket Seat Replacement (Rear Bucket Seat Replacement).




2. Remove the rear screw from the rear seat cushion trim cover.




3. Remove the front screw from the rear seat cushion trim cover.
4. Remove the rear seat belt buckle. Refer to Rear Seat Belt Buckle Replacement (Bucket) Rear Seat Belt Buckle Replacement (Split Bench) .




5. Remove the rear seat cushion trim cover from the rear seat.

Installation Procedure

1. Position the rear seat cushion trim cover to the rear seat.




2. Install the upper retainer clip to the seat frame, pressing into place until fully seated.





Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the rear screw to the seat cushion trim cover.

Tighten the rear seat cushion trim cover screw to 40 Nm (30 lb ft).




4. Install the front screw from the rear seat cushion trim cover.

Tighten the rear seat cushion trim cover screw to 40 Nm (30 lb ft).

5. Install the rear seat belt buckle. Refer to Rear Seat Belt Buckle Replacement (Bucket) Rear Seat Belt Buckle Replacement (Split Bench) .
6. Install the rear bucket seat to the vehicle. Refer to Rear Bucket Seat Replacement (Rear Bucket Seat Replacement).