Rear Seat Cushion Outer Trim Panel Replacement (Split Bench)

Rear Seat Cushion Outer Trim Panel Replacement (Split Bench)

Removal Procedure




1. Remove the screw from the rear seat cushion trim panel.




2. Remove the rear seat cushion trim panel by lifting up to release the retainer from the recliner hinge.

Installation Procedure




1. Install the retainer slot on the rear seat cushion trim panel to tab on the recliner hinge.
2. Install the rear seat cushion trim panel by sliding down until the retainer slot is fully seated on the recliner hinge tab.





Notice: Refer to Fastener Notice .

3. Install the screw to the rear seat cushion trim panel.

Tighten the rear seat cushion trim panel screw to 2 Nm (18 lb in).