General Description

The power sunroof will operate with the ignition switch turned to Accessory or RUN, applying voltage through the sunroof accessory voltage circuit to the sunroof module. Once the ignition switch is turned to OFF the sunroof will continue to operate until any door is open or when the Retained Accessory Power (RAP) has timed out. For a description and operation of the RAP operation, refer to Retained Accessory Power (RAP) Description and Operation in Accessory Delay Module.

Use the rocker type sunroof switch, located in the front center of the headliner, to command the sunroof to:
^ Vent
^ Express Open
^ Close

Pressing the sunroof switch rearward, the sunroof glass will slide from the:
^ Closed position to the vent position
^ Vent position to the open position

Pressing the sunroof switch forward, the sunroof glass will slide from:
^ Open position to the vent position
^ Vent position to the closed position