Rear Floor Rear Trim Plate Replacement

Rear Floor Rear Trim Plate Replacement

Removal Procedure




1. Remove the endgate door sill plate.
2. Remove the endgate door sill plate from the endgate sill.




3. Remove the endgate sill plate push-in retainers if required.

Installation Procedure




1. Install the endgate sill plate push-in retainers and the 4-way locator, pressing in place until fully seated.




2. Align the endgate sill plate to the 4-way locator and the push-in retainers.
3. Install the endgate sill plate to the push-in retainers, applying pressure to secure at all tab locations.