Cargo Area Side Trim Panel Replacement

Cargo Area Side Trim Panel Replacement

Removal Procedure




1. Release the door with the handle and remove the door.
2. Remove the screws holding the access plate.
3. Disconnect the electrical connectors from the panel.
4. Remove the panel.

Installation Procedure




1. Align the panel with the access hole.
2. Connect the electrical connectors to the panel.

Notice: Refer to Fastener Notice .

3. Screw the panel to the cargo side area.

Tighten the screws to 2 Nm (18 lb in).

4. Install the door access panel cover and lock the door with handle.