Instrument Panel Compartment - Door Latch Release Handle Replacement

Instrument Panel Compartment Door Latch Release Handle Replacement

Removal Procedure




1. Open the instrument panel (I/P) compartment door assembly.
2. Remove the screws retaining the I/P compartment door latch to the door.
3. Remove the door handle.

Installation Procedure




1. Install the door handle into position in the I/P compartment door.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the I/P compartment door latch retaining screws.

Tighten the IP compartment door latch retaining screws to 2 Nm (18 lb in).

3. Close the I/P compartment door assembly.