Front End Sheet Metal Diagonal Brace Replacement - Right Side

Front End Sheet Metal Diagonal Brace Replacement - Right Side

Removal Procedure

1. Open the hood.




2. Reposition the underhood wiring junction block from the front fender diagonal brace. Refer to Underhood Electrical Center or Junction Block Replacement .




3. Remove the bolt from the front end sheet metal diagonal brace at the inner fender.
4. Remove the bolts from the front end sheet metal diagonal brace at the radiator support.




5. Remove the front end sheet metal diagonal brace.

Installation Procedure




1. Position the front end sheet metal diagonal brace to the radiator support and to the inner fender.

Notice: Refer to Fastener Notice .




2. Install the bolts to the front end sheet metal diagonal brace at the radiator support.

Tighten the front end sheet metal diagonal brace at radiator support bolts to 10 Nm (89 lb in).

3. Install the bolts to the front end sheet metal diagonal brace at the inner fender.

Tighten the front end sheet metal diagonal brace to the inner fender bolts to 10 Nm (89 lb in).




4. Reposition the underhood wiring junction block to the front fender diagonal brace. Refer to Underhood Electrical Center or Junction Block Replacement .
5. Close the hood.