Wiring Harness Replacement - Rear Door

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Remove the rear door trim panel.
3. Remove the rear door water deflector.
4. Remove the rear door rubber conduit from the rear door.
5. Disconnect the rear door wiring harness connectors from all the accessories.
6. Disconnect the rear door wiring harness rosebud retainers from the inner rear door panel.
7. Remove the rear door wiring harness from the rear door.

INSTALLATION PROCEDURE




1. Install the rear door wiring harness to the rear door.
2. Connect the rear door wiring harness rosebud retainers to the inner rear door panel.
3. Connect the rear door wiring harness connectors to all the accessories.
4. Install the rear door rubber conduit from the rear door.
5. Install the rear door water deflector.
6. Install the rear door trim panel.
7. Connect the negative battery cable.