Rear Bumper Reinforcement: Service and Repair

Rear Bumper Impact Bar Replacement

Removal Procedure




1. Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement (Service and Repair).
2. Remove the energy absorber. Refer to Rear Energy Absorber Replacement (Service and Repair).
3. Remove the impact bar bolts.




4. Remove the impact bar.

Installation Procedure

Important: Position the left side first, then the right side.





1. Position the impact bar to the body using the alignment pin for location.

Notice: Refer to Fastener Notice .




2. Install the impact bar bolts.

Tighten the impact bar bolts to 50 Nm (37 lb ft).

3. Install the energy absorber. Refer to Rear Energy Absorber Replacement (Service and Repair).
4. Install the rear bumper fascia. Refer to Rear Bumper Fascia Replacement (Service and Repair).