Front Bumper Fascia Upper Support Replacement

Front Bumper Fascia Upper Support Replacement

Removal Procedure




1. Remove the fascia. Refer to Front Bumper Fascia Replacement (Front Bumper Fascia Replacement).
2. Remove the hood latch and cable. Refer to Hood Primary Latch Release Cable Replacement (Service and Repair).
3. Disconnect the headlamp wiring harness from the fascia upper support.
4. Remove the bolts from the fascia upper support.




5. Remove the fascia upper support from the upper radiator support.

Installation Procedure




1. Position the fascia upper support to the upper radiator support.

Notice: Refer to Fastener Notice in Cautions and Notices.




2. Install the bolts to the fascia upper support.

Tighten the bolts to 5 Nm (44 lb in).

3. Install the bolts to the fascia lower support.

Tighten the fascia lower support bolts to 10 Nm (89 lb in).

4. Connect the headlamp wiring harness to the fascia upper support.
5. Install the hood latch and cable. Refer to Hood Primary Latch Release Cable Replacement (Service and Repair).
6. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement (Front Bumper Fascia Replacement).