Antenna Cable: Service and Repair
ANTENNA CABLE REPLACEMENTREMOVAL PROCEDURE
IMPORTANT: These procedures are applicable to both of the antenna cables in this vehicle.
1. Remove the radio.
2. Remove the upper trim pad.
3. Remove the trim panel from the right cowl side.
4. Remove the headliner.
5. Remove the antenna cable extension to roof bolt.
6. Remove the antenna cable from the instrument panel carrier.
7. Remove the following components from the vehicle:
^ The antenna cable
^ The antenna cable extension
INSTALLATION PROCEDURE
1. Install the following components to the vehicle:
^ The antenna cable
^ The antenna cable extension
2. Install the antenna cable to the instrument panel carrier.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the bolt which secures the antenna cable extension to the roof.
Tighten
Tighten the bolt to 3.2 N.m (28 lb in).
4. Install the headliner.
5. Install the trim panel at the right cowl side.
6. Install the upper trim pad.
7. Install the radio.