LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2001 >> Aztek Base, AWD >> Repair and Diagnosis >> General Information >> Computer Relearn Procedures >> General Motors (Trucks & Vans) >> Escalade, Pickup, Sierra, SILVERADO, TAHOE, YUKON & YUKON XL >> Password Learn Procedure For Anti-Theft System (4.3L, 4.8L, 5.3L & 6.0L)

Password Learn Procedure For Anti-Theft System (4.3L, 4.8L, 5.3L & 6.0L)

  1. Password relearn procedure must be performed if Passlock® sensor, BCM, PCM or VCM are replaced. Ensure battery is fully charged.
  2. Using scan tool, clear DTCs. Turn ignition switch from OFF to CRANK position, allowing vehicle to try and start. Vehicle will start and then stall. Leave ignition switch turned to ON position while observing SECURITY indicator on instrument panel. When security indicator turns off (after about 10 minutes), turn ignition off. Wait 10 seconds. Repeat this step 3 more times. New password will be learned on next start attempt.