LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1996 >> Firebird Formula, 2D Convertible, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Bleeding Brake System >> Manual Bleeding >> Brake Control Assembly (Bleeding)

Brake Control Assembly (Bleeding)

  1. Verify reservoir is full. Attach a clear hose to rear bleeder valve, and submerge other end of hose in clean container.
  2. Press and hold brake pedal. Slowly open rear bleeder and allow fluid to flow. Close valve, and release brake pedal. Wait 5 seconds. Repeat procedure until no air bubbles are seen in hose. Repeat procedure for front bleeder valve.
  3. Turn ignition on. Apply moderate force to brake pedal noting travel and feel. If pedal is firm and travel is not excessive, start engine and recheck. If okay, go to step 5). If pedal feels soft or has excessive travel, go to next step.
  4. To ensure all trapped air has been removed from the brake control assembly, connect Tech 1 scan tool to DLC. Using Tech 1 scan tool, release then apply each ABS motor 2-3 times and cycle each ABS solenoid 5-10 times. Repeat manual bleeding procedure. Road test vehicle, making several normal (non-ABS) stops from a moderate speed.
scientia non olet · About LEMON Manuals