LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1995 >> Firebird Formula, 2D Convertible, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Servicing >> HARRISON Hr100T & Hr110-MD 4-Cylinder >> Clutch Plate >> Removal

Clutch Plate: Removal

  1. If compressor is on vehicle, loosen mounting brackets, disconnect drive belt and position compressor for easy access. Using a spanner wrench, remove shaft nut (if equipped). It is not necessary to discharge system. If compressor has been removed from vehicle, use Holding Fixture (J-25008-A) and vise to support compressor.
  2. Thread Clutch Plate Remover (J-33013-B) into clutch plate. Hold body of clutch plate remover. Tighten center bolt to remove clutch plate. Remove compressor shaft key. See Figure.
scientia non olet · About LEMON Manuals