LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1995 >> Firebird Formula, 2D Convertible, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical 3.8L V6 - VIN [K] >> Removal & Installation >> Intake Manifold (Lower) >> Installation (Lower)

Installation (Lower)

  1. Ensure sealing surfaces and bolt threads and holes are clean. Apply GM Sealant (12345336) at end of seals on cylinder block. Install manifold and gaskets. Coat bolt threads with thread locking compound.
  2. Tighten bolts to specification in sequence. See Fig 1 or Fig 2 .
  3. Lubricate fuel rail "O" rings with engine oil. To complete installation, reverse removal procedure. Fill and bleed cooling system. See COOLING SYSTEM BLEEDING  .
Fig 1: Lower Intake Manifold Bolt Tightening Sequence - "F" Body
G97J03611Courtesy of GENERAL MOTORS CORP.
Fig 2: Lower Intake Manifold Bolt Tightening Sequence - Except "F" Body
G97H03610Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals